How to Clean iPhone charging port? There are a couple of reasons that your iPhone won’t be charging properly; as discussed within the article “Why won’t my iPhone charge? You would possibly have to restart your phone. Also you should check the Lightning cable for kinks and breaks, and ensure your power source is functioning. If you check all those things and it still doesn’t work, it’s possible there’s enough debris in your port to stop the connector from making a solid connection.
Anytime you set it in a pocket or bag, small bits of dirt and dust, and maybe lint can find their way in. And once you insert the cable, that compresses and packs the dirt deep within the port. it’d become so fouled with debris that it stops working.
You should get a flashlight, or work under a bright LED desk lamp — the brighter the higher, since you would like to ascertain deep into the Lightning port.
And while you’ll want to start out with compressed gas, if you’re getting to insert anything into the port to tug out wedged-in dirt, there’s just one acceptable tool for the job: A toothpick. Never attempt to clean the Lightning port with anything harder than wood, like all kinds of pin or metal rod. There are delicate electronics within the port, and ramming it with a pointy metal pin can permanently damage it.
- Power off your iPhone completely. you’ll open the Settings app then tap “General,” followed by “Shut Down.”
- Holding the compressed gas upright (so it only blasts air, and doesn’t expel wet propellant) shoot a couple of short, controlled bursts into the port.
- Turn your phone on and check out to charge it again. If it’s still not working, it is time to undertake the toothpick.
- Together with your phone turned off, insert the toothpick into the port and lightly scrape it against the within wall of the port. Don’t try to apply pressure to the wall that’s closest to the front of the phone, because there are delicate pins there. Overall, it is vital to be gentle, because additionally to those pins, the edges are home to 2 small spring-mounted anchors that latch onto the Lightning port once you insert it (that’s why it “snaps” into place once you push the cable in). If you break anything, its charging days are going to be over permanently.
- After using the toothpick for a short time , give the port another burst of compressed gas to assist remove anything you’ve loosened.
- If you push dirt out.
- turn the phone back on and check to charge it.
If it works, congratulations you’re now back in business. If it still doesn’t work, you’ll still try — carefully — or take it to an Apple service center for professional help.
We hope you will like our this article on How to Clean iPhone charging port?